333
months after orthognathic surgery showed a change in the pre-
dispositions 23% of the patients submitted to bimaxillary surgery.
15%changed their resistance frommoderate tomild and 8%severe
to moderate. There is a tendency to increased volumetric dimen-
sion of the upper airways after orthognathic surgery in patients
with class III skeletal dimorphism, mandibular prognathism and
maxillary deficiency.
http://dx.doi.org/10.1016/j.ijom.2017.02.1120Pre- and postsurgical evaluation of the position and stability
over time of the base of tongue, hyoid bone and airway
volume in skeletal class III patients submitted to
orthognathic surgery
J. Vallejo
University of Antioquia, Medellín, Colombia
Background:
The purpose of this study is to examine changes in
the stability of the volumetric capacity of the upper airway, the
position of the base of the tongue and the hyoid bone in patients
Class III treated with orthognathic surgery.
Methods:
The reference measurements in air, base of the tongue
and hyoid bone by using the program 5 INVIVO in a sample of 19
Class III patients treated with orthognathic surgery, in which the
preoperative measurement (T0), four months postoperative (T1)
and after eight months after surgery (T2) is done.
Results:
An increasing trend higher volumetric capacity relating
the different times shown a tendency to increase as the volume of
air in T0 and T1 which remained at T2, postoperative retraction of
the hyoid bone is presented with an advance T2 and a tongue base
with recoil and decrease in T1 with a regression to the original
position in T2.
Conclusions:
In the treatment of orthognathic surgery in patients
with class III there was a trend of increasing the volumetric
capacity of the upper airway in T1 and a tendency to decreased
volumetric capacity in T2, having direct relation to the change in
the hyoid bone position with a previous, as the base of the tongue,
which have a tendency to reset the initial position.
http://dx.doi.org/10.1016/j.ijom.2017.02.1121Bilateral sagittal split osteotomy with splitter and separators,
risk factors for complications
J. Verweij
∗
, G. Mensink, P. Gooris, R. van Merkesteyn
Leiden University Medical Centre, Leiden, The Netherlands
Background:
Bilateral sagittal split osteotomy (BSSO) is awidely
used orthognathic surgical technique. It is generally considered the
golden standard to treat mandibular deformity.
Objectives:
This study investigated BSSO with splitter and sepa-
rators. The occurrences of common complications and their risk
factors are assessed.
Methods:
BSSO was performed according to the Hunsuck mod-
ification with splitter and separator without the use of chisels.
Retrospective analysis was performed of more than 250 patients.
The incidences of common complications, including neurosensory
disturbances of the lower lip (hypoaesthesia), bad split, postopera-
tive infection, and removal of osteosynthesis material are reported.
The patients’ age, gender, and the presence of third molars were
analysed as risk factors for complications.
Findings:
BSSO with splitter and separators is associated with
a low mean incidence of permanent hypoaesthesia of 9.9% per
patient. Age was a significant risk factor for hypoaesthesia with
marked differences between age groups (30 years, 15.2%). The
incidence of bad split was 4.0% per patient. Intraoperative pres-
ence of third molars significantly increased the risk of bad split.
Infection occurred in 15.1% of patients. Removal of bicortical
screw osteosynthesis material because of symptoms was indicated
in 4.9% of patients. No significant risk factors were recorded for
infection or removal of osteosynthesis material.
Conclusion:
BSSO with splitter and separators without the use of
chisels is associated with a low risk of hypoaesthesia. Relevant risk
factors for complications are age (hypoaesthesia) and the presence
of third molars during surgery (bad split).
http://dx.doi.org/10.1016/j.ijom.2017.02.1122The application of virtual orthognathic design in the
treatment of dentomaxillofacial deformities
M.J. Wang
∗
, H.L. Li, J.W. Si, X.D. Wang, H.B. Yu,
S.G.F. Shen
Shanghai Key Laboratory of Stomatology, Department of Oral
and Craniomaxillofacial Surgery, Ninth People’s Hospital,
College of Stomatology, Shanghai Jiao Tong University School
of Medicine, Shanghai, China
Background:
Dentomaxillofacial deformities are usually located
in a three-dimensional space and present as structural abnormi-
ties of the jaw, while the traditional craniofacial modelling tends
to focus on dental occlusions and does not directly reflect the
movement of the jaw.
Objectives:
This study was to explore the application of vir-
tual orthognathic design in the treatment of dentomaxillofacial
deformities.
Methods:
Fifteen patients with dentomaxillofacial deformities
were enrolled in this study. A digital craniomaxillofacial-dentition
model was established by combining three-dimensional (3D)
computed tomography (CT) and laser-scanned dentition models.
Based on this composite model, surgical planning, simulations,
and postoperative predictions were performed. Under the guid-
ance of a 3D printed splint and guide, orthognathic surgeries
and asymmetry corrections were performed. Clinical examina-
tions were performed 3 months after surgery. Surgical accuracy
was evaluated by comparing the postoperative CT 3D model with
preoperative surgical planning.
Findings:
All patients successfully underwent virtual surgical
planning, splint and guide 3D printing, and orthognathic surgery.
Facial symmetry was greatly improved after surgery. The mean
deviation between the preoperative design and actual surgical
results was less than 2 mm.
Conclusion:
With preoperative planning, surgical simulation, and
postoperative prediction, virtual orthognathic design demonstrates
great value in improving the accuracy of orthognathic surgery and
restoring facial symmetry. It is regarded as a valuable technique to
improve the results and execution of this potentially complicated
procedure.
http://dx.doi.org/10.1016/j.ijom.2017.02.1123




